UK price guide

What is used pallet racking worth?

Between roughly £80 and £460 a bay, and the reason that range is so wide is more useful than any single figure inside it. A bay bought off a classified ad and collected yourself sits at the bottom; the same bay delivered, inspected and warranted by a dealer sits at the top.

Researched 23 October 2026. Asking prices, not sold prices — see the limits at the foot of this page.

What the market is asking, per bay unless stated

MeasureAskingSource
Used, specialist supplier estimate£80–180UM Storage Systems (seller-published)
Used standard adjustable, 2026 guide£95–140UM Storage Systems, new vs used 2026 (seller-published)
Used starter bays, dealer retail£160–360 ex VATMonarch Shelving (seller-published)
Complete used bays, dealer retail£350–460 ex VATThe Used Racking (seller-published)
Single bays, classified listings£100–150Gumtree
New, for comparison£150–350UM Storage Systems (seller-published)
100-pallet-position run, used and inspected£3,800–6,200 (about £38–62 a position)UM Storage Systems, 2026 guide (seller-published)
100-pallet-position run, new and installed£8,500–12,000UM Storage Systems, 2026 guide (seller-published)

Why the range is that wide

A used bay is £100 on a classified ad and £400 from a dealer, and neither price is wrong. The gap is almost entirely what comes with it: whether it is delivered or you dismantle and collect it yourself, whether the uprights have been checked, whether the manufacturer and profile are consistent across the whole lot, and whether anyone will certify the installation afterwards. Racking that cannot be certified once it is reinstalled is worth what the steel weighs, which is why the cheapest option is sometimes the most expensive one.

What moves the number

The bottom metre of every upright

This is where forklift strikes land and where water sits. A dented upright changes the rated load of the whole bay, and the rating is what an insurer and a SEMA inspector will ask about.

Consistent manufacturer and profile

Dexion beams in a Link 51 frame is not a bargain, it is a bay nobody will certify. A mixed lot is worth materially less than the sum of its parts.

Frame height and beam levels

More usable positions per bay raises the value per bay. Very tall frames narrow the buyer pool, because they need the roof height and the right truck.

Who dismantles it

Racking taken down badly is scrap. A seller who has it dismantled properly, or lets the buyer do it, protects most of the value; one who has a general labourer attack it with a crowbar does not.

Quantity in one lot

A complete consistent run is worth more per bay than the same bays split up, because it saves the buyer the matching problem entirely.

Got some to sell?

Listing on LotLoop costs nothing and always will — sellers pay 0% commission, permanently, and it is not a promotion. You receive the full amount you list or agree, because the LotLoop commission sits on the buyer’s price rather than being deducted from yours.

Send what you already have — a stock sheet, a spreadsheet, a few phone photos — and LotLoop writes the listing from it. Nothing is published until you have read it back and approved it.

Looking to buy instead?

LotLoop may not have one listed today. Tell us what you need and we will tell you when it arrives — the request takes a minute and it is what we show sellers when we ask them for stock.

The limits of these figures

  • These are asking prices, not sold prices. No UK transaction data for used commercial equipment is published, which is the same reason this page needed writing.
  • Most of the figures above come from businesses that sell racking, and are marked where that is the case. A seller's published range is evidence, not a valuation.
  • Several of the source pages were more than 200 days old when checked.
  • VAT and installation are excluded unless the figure says otherwise.

If you know this market better than these figures suggest — and if you trade in it, you probably do — tell us and we will correct the page. hello@lotloop.co.uk.